User:Wizzup/Jenkins - Revision history

Wizzup at 08:55, 28 April 2022

2022-04-28T08:55:43Z

← Older revision		Revision as of 08:55, 28 April 2022
Line 10:		Line 10:
	useradd -m -s /bin/bash jenkins		useradd -m -s /bin/bash jenkins
	passwd jenkins		passwd jenkins
	su - jenkins # add key		su - jenkins # add ssh pub key from jenkins master to .ssh/authorized_keys
	apt install sudo		apt install sudo
	sudo vi /etc/sudoers # allow passwordless sudo for sudo group		sudo vi /etc/sudoers # allow passwordless sudo for sudo group
	gpasswd -a jenkins sudo		gpasswd -a jenkins sudo
			</pre>

			Also, this might not be necessary, but one could add this:

			<pre>
			# cat /etc/sudoers.d/jenkins
			jenkins ALL=NOPASSWD: /usr/sbin/cowbuilder, /usr/sbin/chroot, /bin/chmod, /bin/rm, /bin/mv, /bin/cat
			Defaults env_keep+="DEB_* DIST ARCH ADT QEMU_LOG_FILENAME"
	</pre>		</pre>

Wizzup at 08:36, 28 April 2022

2022-04-28T08:36:38Z

Show changes

Wizzup: Created page with "Setting up a Jenkins build slave requires the following steps to be executed on a machine that matches the Maemo devuan version (Not sure if this is strictly required, we just..."

2022-04-28T08:34:21Z

Created page with "Setting up a Jenkins build slave requires the following steps to be executed on a machine that matches the Maemo devuan version (Not sure if this is strictly required, we just..."

New page

Setting up a Jenkins build slave requires the following steps to be executed on a machine that matches the Maemo devuan version (Not sure if this is strictly required, we just did it that way before).

{{{
apt install default-jre-headless
apt install jenkins-debian-glue jenkins-debian-glue-buildenv-devuan
apt purge exim4-base exim4-config exim4-daemon-light
apt --purge autoremove
apt install ntp

useradd -m -s /bin/bash jenkins
passwd jenkins
su - jenkins # add key
apt install sudo
sudo vi /etc/sudoers # allow passwordless sudo for sudo group
gpasswd -a jenkins sudo
}}}

Also copy over /etc/jenkins from one of the existing nodes, specifically for the debian glue config, see below.

Then add it to Jenkins as a node (I just copied an existing node and changed the host/ip).

Then run a build, it will likely fail, because our keys are not yet added to the pbuilder environment that just got created during the first build.

Add it like so:

{{{
cd /var/cache/pbuilder/base-beowulf-arm*.cow
wget https://maedevu.maemo.org/extras-key.asc
wget https://maedevu.maemo.org/testing-key.asc

chroot /var/cache/pbuilder/base-beowulf-arm*.cow
apt install gnupg1
apt-key add < extras-key.asc
apt-key add < testing-key.asc
rm *.asc
exit
cd -
}}}