Difference between revisions of "Status/USB Peripheral"
From Maemo Leste Wiki
Jump to navigationJump to search (enable iptables note) |
|||
| (4 intermediate revisions by 2 users not shown) | |||
| Line 2: | Line 2: | ||
Mass Storage may show as an option, but doesn't do anything useful yet. | Mass Storage may show as an option, but doesn't do anything useful yet. | ||
== Bringing up network on your PC == | |||
After plugging USB from your device into your PC, issue: | |||
<pre> | <pre> | ||
ip link set usb0 up # this one might not really be necessary | |||
ip address add 192.168.42.1/24 dev usb0 | |||
ssh root@192.168.42.2 | ssh root@192.168.42.2 | ||
</pre> | </pre> | ||
The default password is <code>toor</code>. | |||
== Share PC network with Leste device == | |||
To also have the devices use your PC network, log into the devices: | |||
The default password is <code>toor</code>. (user: <code>root</code>) | |||
And then add the following route on the device: | And then add the following route on the device: | ||
| Line 34: | Line 39: | ||
Now your Leste device should be able to use your PC network | Now your Leste device should be able to use your PC network | ||
== Share Leste network with PC over USB == | |||
On PC (as root): | |||
<pre> | |||
ifconfig usb0 up 192.168.42.1 | |||
ip route add default via 192.168.42.2 | |||
</pre> | |||
On Leste (as root): | |||
<pre> | |||
iptables -A FORWARD -i wlan0 | |||
iptables -A POSTROUTING -t nat -s 192.168.42.1/32 -j MASQUERADE | |||
echo 1 > /proc/sys/net/ipv4/ip_forward | |||
echo 1 > /proc/sys/net/ipv4/conf/wlan0/forwarding | |||
</pre> | |||
If you want to share the wwan instead, switch out wlan0 for the wwan (e.g. on the Droid that is 'wwan3'). | |||
== Notes == | == Notes == | ||
* The default IP address is configured in <code>/usr/sbin/pcsuite-enable.sh</code> | * The default IP address is configured in <code>/usr/sbin/pcsuite-enable.sh</code> | ||
Latest revision as of 11:10, 27 March 2021
Currently, devices that are supported by Maemo Leste will automatically set up USB networking if you plug them into a PC. Mass Storage may show as an option, but doesn't do anything useful yet.
Bringing up network on your PC
After plugging USB from your device into your PC, issue:
ip link set usb0 up # this one might not really be necessary ip address add 192.168.42.1/24 dev usb0 ssh root@192.168.42.2
To also have the devices use your PC network, log into the devices:
The default password is toor. (user: root)
And then add the following route on the device:
ip route add default via 192.168.42.1 # if this fails, first run ip route del default
On your PC, issue:
# (Maybe only one of these two echos is necessary) echo 1 > /proc/sys/net/ipv4/conf/usb0/forwarding echo 1 > /proc/sys/net/ipv4/ip_forward iptables -A POSTROUTING -t nat -s 192.168.42.2/32 -j MASQUERADE
Make sure that forwarding is also allowed within iptables itself, enable it with iptables --policy FORWARD ACCEPT
Now your Leste device should be able to use your PC network
On PC (as root):
ifconfig usb0 up 192.168.42.1 ip route add default via 192.168.42.2
On Leste (as root):
iptables -A FORWARD -i wlan0 iptables -A POSTROUTING -t nat -s 192.168.42.1/32 -j MASQUERADE echo 1 > /proc/sys/net/ipv4/ip_forward echo 1 > /proc/sys/net/ipv4/conf/wlan0/forwarding
If you want to share the wwan instead, switch out wlan0 for the wwan (e.g. on the Droid that is 'wwan3').
Notes
- The default IP address is configured in
/usr/sbin/pcsuite-enable.sh
