Difference between revisions of "Status/USB Peripheral"
From Maemo Leste Wiki
Jump to navigationJump to search (add default password) |
(add default config file) |
||
| Line 32: | Line 32: | ||
Now your Leste device should be able to use your PC network | Now your Leste device should be able to use your PC network | ||
== Notes == | |||
* The default IP address is configured in <code>/usr/sbin/pcsuite-enable.sh</code> | |||
Revision as of 23:47, 20 September 2019
Currently, devices that are supported by Maemo Leste will automatically set up USB networking if you plug them into a PC. Mass Storage may show as an option, but doesn't do anything useful yet.
To also have the devices use your PC network, log into the devices:
ifconfig usb0 up 192.168.42.1 ssh root@192.168.42.2
The default password is toor.
And then add the following route on the device:
ip route add default via 192.168.42.1 # if this fails, first run ip route del default
On your PC, issue:
# (Maybe only one of these two echos is necessary) echo 1 > /proc/sys/net/ipv4/conf/usb0/forwarding echo 1 > /proc/sys/net/ipv4/ip_forward iptables -A POSTROUTING -t nat -s 192.168.42.2/32 -j MASQUERADE
Now your Leste device should be able to use your PC network
Notes
- The default IP address is configured in
/usr/sbin/pcsuite-enable.sh
