Difference between revisions of "Status/USB Peripheral"
From Maemo Leste Wiki
Jump to navigationJump to search| Line 16: | Line 16: | ||
To also have the devices use your PC network, log into the devices: | To also have the devices use your PC network, log into the devices: | ||
The default password is <code>toor</code>. | The default password is <code>toor</code>. (user: <code>root</code>) | ||
And then add the following route on the device: | And then add the following route on the device: | ||
Revision as of 21:47, 23 February 2020
Currently, devices that are supported by Maemo Leste will automatically set up USB networking if you plug them into a PC. Mass Storage may show as an option, but doesn't do anything useful yet.
Bringing up network on your PC
After plugging USB from your device into your PC, issue:
ifconfig usb0 up 192.168.42.1 ssh root@192.168.42.2
To also have the devices use your PC network, log into the devices:
The default password is toor. (user: root)
And then add the following route on the device:
ip route add default via 192.168.42.1 # if this fails, first run ip route del default
On your PC, issue:
# (Maybe only one of these two echos is necessary) echo 1 > /proc/sys/net/ipv4/conf/usb0/forwarding echo 1 > /proc/sys/net/ipv4/ip_forward iptables -A POSTROUTING -t nat -s 192.168.42.2/32 -j MASQUERADE
Make sure that forwarding is also allowed within iptables itself, enable it with iptables --policy FORWARD ACCEPT
Now your Leste device should be able to use your PC network
Notes
- The default IP address is configured in
/usr/sbin/pcsuite-enable.sh
