Status/USB Peripheral

Currently, devices that are supported by Maemo Leste will automatically set up USB networking if you plug them into a PC. Mass Storage may show as an option, but doesn't do anything useful yet.

Bringing up network on your PC

After plugging USB from your device into your PC, issue:

ip link set usb0 up  # this one might not really be necessary
ip address add 192.168.42.1/24 dev usb0
ssh root@192.168.42.2

Share PC network with Leste device

To also have the devices use your PC network, log into the devices:

The default password is toor. (user: root)

And then add the following route on the device:

ip route add default via 192.168.42.1
# if this fails, first run ip route del default

On your PC, issue:

# (Maybe only one of these two echos is necessary)
echo 1 > /proc/sys/net/ipv4/conf/usb0/forwarding
echo 1 > /proc/sys/net/ipv4/ip_forward

iptables -A POSTROUTING -t nat -s 192.168.42.2/32 -j MASQUERADE

Make sure that forwarding is also allowed within iptables itself, enable it with iptables --policy FORWARD ACCEPT

Now your Leste device should be able to use your PC network

Notes

• The default IP address is configured in /usr/sbin/pcsuite-enable.sh